For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. Please use a
suitable spanner.
To allow the doors to self-close, tilt
back the top backwards at about
15mm or 0.5 by turning the adjustable
feet.
Whenever you want to move the
appliance, remember to turn the feet
back up, so that the appliance can
roll freely. Reinstall the appliance
whenrelocating.
Leveling of appliance
For proper installation, this
refrigerator must be placed on a
level surface of hard material
that is the same height as the
rest of the flooring, This surface
should be strong enough to
support a fully loaded
refrigerator.
The rollers, which are not castors,
should be only used for forward
or backward movement. Moving
the refrigerator sideways may
damage your floor and the
rollers.
Warning
09
Installing your new appliance
Adjustable
bottom feet
Front roller Rear roller
0.4"-0.6"
Adjustable
bottom feet
The height of a door can be adjusted
using the provided Snap Rings.
Tools you will need:
Adjusting Door Height and Door Gap
Snap Ring (4pcs)
Wrench(Not provided)
To Next Page
Loading...
