8
Stand your appliance in a dry place to
avoid high moisture.
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away
from heat sources such as stoves, fires or
heaters.
Leveling of appliance
For sufficient leveling and air circulating in
the lower rear section of the appliance, the
bottom feet may need to be adjusted. You
can adjust them manually by hand or by
using a suitable spanner.
To allow the doors to self-close, tilt the top
backwards by 10-15mm.
Note:
If required you may lay the refrigerator on
its back in order to gain access to the base,
you should rest it on soft foam packaging
or similar material to avoid damaging the
backboard of the refrigerator.
There is no need to install these
accessories under normal usage.
Only under the extreme circumstances
, cabinet empty while load on fridge door
with heavy weight, at the same time
opening the doors about 90 degree, the
refrigerator maybe lean forward. Then
rubber supporting pad should be fastened
to the lower base cover to steady this
appliance.
1. Tilt appliance to find screw hole on the
left of lower base cover.
2. Put screw into the hole of rubber
supporting pad.
3. Make screw in alignment with the hole
on lower base cover. Fasten rubber
supporting pad to the base cover firmly by
a cross screwdriver (self-provided).
①
screw
cross screwdriver
To Next Page
Loading...
