EasyManuals Logo

Hisense RS818N4TFE User Manual

Hisense RS818N4TFE
Go to English
213 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
You may have left the doors open too long or too frequently; or the
doors are kept open by some obstacle; or the appliance is located
with insufficient clearance at the sides, back and top.
Increase the temperature by following the”Display controls” chapter.
Check whether the top of the refrigerator is tilted back by mm10-15
to allow the doors to self close, or if something inside is preventing
the doors from closing.
The water pan (located at the rear bottom of the cabinet)
may not be properly leveled, or the draining spout under
neath the top of the compressor depot may not be properly
positioned to direct water into this pan, or the water spout
is blocked. You may need to pull the refrigerator away from
the wall to check the pan and spout.
Check if the refrigerator is power-off for a long time, this
may cause the ice in the bucket to melt into water,
and flow to the floor .
The LED light may be damaged. Refer to replace LED lights in
cleaning and care chapter.
The control system has disabled the lights due to the door being
kept open too long, close and reopen the door to reactivate the
lights.
It is normal to frequently hear the sound of the motor, it will need to
run more during following circumstances:
Temperature setting is set colder than necessary.
Large quantity of warm food has recently been stored within the
appliance.
The temperature outside the appliance is too high.
Doors are kept open too long or too often.
After your installing the appliance or it has been switched off for a
long time.
The motor runs
continuously
Temperature
inside is too warm
Temperature
inside is too cold
Doors cant be
closed easily
Water drips on
the floor
The light is not
working
before making ice? if it is not sufficiently cool, it may take longer to
make ice, such as when first installed.
Did you manually stop the ice making function? Make sure you
have set the Cubed or Crushed mode on.
Ice is not
dispensing
A layer of frost
occurs in the
compartment
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation. Ensure
the door can be fully closed. To remove the frost, please refer to the
cleaning and care chapter.
Did you wait for 10 hours after installation of the water supply line
Is the water storage box installed accurately? Make sure
there is enough water in the water storage box..
27
58 / 213

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hisense RS818N4TFE and is the answer not in the manual?

Hisense RS818N4TFE Specifications

General IconGeneral
Control typeTouch
Display typeLED
Product colorBlack
Product designAmerican door
Built-in displayYes
Shelves materialTempered glass
Appliance placementFreestanding
Number of compressors1
Fridge net capacity417 L
Number of vegetable drawers2
Fridge number of shelves/baskets3
Noise level38 dB
Water filterNo
CertificationCE, UKCA
Climate classSN-T
Cooling systemVentilated
Water supply typeWater tank
Total net capacity632 L
Water tank capacity4.5 L
Cord length2 m
Star rating4*
Freezer positionSide-placed
Freezing capacity11 kg/24h
Freezer net capacity215 L
Freezer number of shelves/baskets4
Storage time during power failure8 h
Power plug typeType G
AC input voltage220-240V V
AC input frequency50 Hz
Annual energy consumption346 kWh
Package depth787 mm
Package width978 mm
Package height1860 mm
Package weight128000 g
Country of originChina
Weight and Dimensions IconWeight and Dimensions
Depth730 mm
Width910 mm
Height1790 mm
Weight118000 g

Related product manuals