Hisense RS694N4IIF User Manual (English)

Questions and Answers:

D
Dr. Mary HallAug 15, 2025
What to do if my Hisense Refrigerator is not working correctly?
- S
  Sonya MccormickAug 15, 2025
  First, ensure the power cord is properly plugged into the outlet. Then, check the fuse or circuit of your power supply and replace it if needed. If the ambient temperature is too low, try setting the chamber temperature to a colder level. Also, the freezer may not operate during the automatic defrost cycle, or shortly after being switched on, to protect the compressor, which is normal.
H
Heather McdanielAug 18, 2025
Why is my Hisense RS694N4IIF Refrigerator temperature inside too warm?
- D
  Douglas MarshallAug 18, 2025
  The temperature inside the refrigerator might be too warm if the doors have been left open too long or too frequently, or if something is preventing the doors from closing properly. Insufficient clearance at the sides, back, and top of the appliance can also cause this issue.
M
Matthew AguirreAug 21, 2025
Why is my Hisense RS694N4IIF water dispenser not functioning?
- T
  tayloraudreyAug 21, 2025
  Check that the water line is connected and the water valve is open. Also, ensure the water line hasn't been crushed or kinked, and that it's free of any obstructions. If the water tank is frozen because the refrigerator temperature is too low, select a warmer setting on the display panel. Lastly, make sure the filter is properly installed.
E
Evan RiveraAug 25, 2025
What to do if my Hisense RS694N4IIF Refrigerator has a layer of frost in the compartment?
- C
  christinawilsonAug 25, 2025
  Ensure that the air outlets are not blocked by food and that food is placed to allow sufficient ventilation. Also, make sure the door can be fully closed. To remove the frost, please refer to the cleaning and care chapter.
E
erikmarquezAug 27, 2025
What to do if my Hisense RS694N4IIF Refrigerator is dripping water on the floor?
- M
  Miss Jessica Brown MDAug 27, 2025
  Check if the water pan (located at the rear bottom) is properly leveled. Also, ensure the draining spout underneath the top of the compressor depot is correctly positioned to direct water into the pan. The water spout might also be blocked. Ensure the water is fully inserted into the connector. You may need to pull the refrigerator away from the wall to check these components.