EasyManuals Logo

Hisense RS818N4TIC User Manual

Hisense RS818N4TIC
Go to English
218 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #214 background imageLoading...
Page #214 background image
You may have left the doors open too long or too frequently; or the
doors are kept open by some obstacle; or the appliance is located
with insufficient clearance at the sides, back and top.
Increase the temperature by following the”Display controls” chapter.
Check whether the top of the refrigerator is tilted back by mm10-15
to allow the doors to self close, or if something inside is preventing
the doors from closing.
The water pan (located at the rear bottom of the cabinet) may
not be properly leveled, or the draining spout under neath the
top of the compressor depot may not be properly positioned to
direct water into this pan, or the water spout is blocked. You
may need to pull the refrigerator away from the wall to check the
pan and spout. Check if the refrigerator is power-off for a long
time, this may cause the ice in the bucket to melt into water, and
flow to the floor .
The LED light may be damaged. Refer to replace LED lights in
cleaning and care chapter.
The control system has disabled the lights due to the door being
kept open too long, close and reopen the door to reactivate the
lights.
It is normal to frequently hear the sound of the motor, it will need to
run more during following circumstances:
Temperature setting is set colder than necessary.
Large quantity of warm food has recently been stored within the
appliance.
The temperature outside the appliance is too high.
Doors are kept open too long or too often.
After your installing the appliance or it has been switched off for a
long time.
The motor runs
continuously
Temperature
inside is too warm
Temperature
inside is too cold
Doors can’t be
closed easily
Water drips on
the floor
The light is not
working
before making ice? if it is not sufficiently cool, it may take longer to
make ice, such as when first installed.
have set the Cubed or Crushed mode on.
Ice is not
dispensing
A layer of frost
occurs in the
compartment
Check that the air outlets are not blocked by food and ensure food
is placed within the appliance to allow sufficient ventilation. Ensure
the door can be fully closed. To remove the frost, please refer to the
cleaning and care chapter.
Did you wait for 10 hours after installation of the water supply line
Is the water storage box installed accurately? Make sure
there is enough water in the water storage box..
Did you manually stop the ice making function? Make sure you
28

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hisense RS818N4TIC and is the answer not in the manual?

Hisense RS818N4TIC Specifications

General IconGeneral
Star rating4*
Freezer positionSide-placed
Freezing capacity11 kg/24h
Fast freeze functionYes
Freezer net capacity215 L
Freezer number of doors1
Freezer temperature (min)-18 °C
Freezer number of shelves/baskets4
Storage time during power failure5.5 h
Freezer number of vegetable drawers2
Door opening angle130 °
Cord length2 m
Temperature alarmNo
Control typeTouch
Display typeLED
Product colorStainless steel
Product designAmerican door
Appliance placementFreestanding
Fresh zone compartment-
Package depth775 mm
Package width978 mm
Package height1860 mm
Package weight128000 g
AC input voltage220-240 V
AC input frequency50 Hz
Energy efficiency scaleA to G
Annual energy consumption221 kWh
Noise level36 dB
CertificationCE, UKCA
Climate classN-T
Water supply typeWater tank
Total net capacity632 L
Fridge net capacity417 L
Fridge number of shelves/baskets3
Weight and Dimensions IconWeight and Dimensions
Depth730 mm
Width910 mm
Height1790 mm
Weight118000 g
Width with door open1563 mm

Related product manuals