EasyManuals Logo

Hisense RT393D4AW1 User Manual

Hisense RT393D4AW1
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
The food is too warm.
Interior lighting does
not work.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing t
he
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Please look in the “initial Start Up”
section.
Open the door only as long as
necessary.
Turn th
e temperature regulation
to a colder setting temporarily.
Please look in the “installation
location” section.
Please look in the “changing the
Light Bulb “section.
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the warmed
door seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slight
ly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
See the “cleaning and care”
section.
Warning!
If the light bulb is damaged, only a
qualified electrician of competent
person must carry out it!Changing
th e l ight b ulb carry out by
inexperienced persons may cause
injury or serious malfunctioning. it
must be replaced by a qualified
persons in order to avoid a hazard.
Contact your local Service Force
Center for help.
Light bulb data: 220-240 V,max.15W.
To switch off the appliance, set the
temperature re
gulator to position “0”.
Unplug the mains plug
To change the light bulb, undo the screw.
Press the light bulb cover and slide it
backwards.
Change the defective light bulb.
Refit the light bulb cover and the screw.
Put the refrigerator back into operation.
Changing the light bulb
Bulb
Bulb cover
Screw
Control Box
Heavy build-up of
frost, possibly also on
the door seal.
33

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hisense RT393D4AW1 and is the answer not in the manual?

Hisense RT393D4AW1 Specifications

General IconGeneral
BrandHisense
ModelRT393D4AW1
CategoryRefrigerator
LanguageEnglish

Related product manuals