Stand your appliance in a
dry place to avoid high
moisture.
For sufficient leveling and
air circulating in the lower
rea r secti o n o f t h e
appliance, the bottom feet
may need to be adjusted.
You can adjust them
manually by hand or by
using a suitable spanner.
To allow the doors to self-
close, tilt the top backwards
by about 10mm.
Keep the appliance out of
direct sunlight rain or frost.
Stand the appliance away
from heat sources such as
stoves, fires or heaters.
Leveling of appliance
●
●
●
●
Reversing the door
The side at which the door
opens can be changed,
from the right side (as
supplied) to the left side, if
the installation site requires.
Note: Before you start lay
the refrigerator
the base you should rest
it on soft foam packaging
or similar material to avoid
damaging the backboard
of the refrigerator. To
reverse the door the
following steps are
generally recommended
1. Stand the refrigerator
upright Open the upper
door to take out all door
racks (to avoid rack
sdamaged) and then close
the door
on its back
in order to gain access to
,
,
.
.
.
≤10mm
Hisense Refrigerator
Tools you will need
Warning! When reversing
the door, the appliance
must not be connected to
the mains. Ensure that the
plug is removed from the
mains socket.
8
8mm socket wrench
Cross-shaped screwdriver
Monkey wrench
8mm wrench
Thin-blade screwdriver
To Next Page
Loading...
