information.
Insert SIM/USIM card with the metal contacts facing down
and the cut corner aligned with that of the slot.
Notes:
1. If no card is installed, the string of “No SIM Card” will
display on the screen.
2. If your card is PIN-locked your phone will display “SIM
card is locked”. You must enter PIN before the phone
can start working. Please contact your network service
provider if you need.
3. When inserting card, please keep it away from
possible damage caused by static, scratch and bend,
and put it where is not available for children.
Inserting SD card
Insert SD card with the metal contacts facing down and the
cut corner aligned with that of the slot.
Installing the battery
You must install and charge the battery to use your phone.
Insert the ridge at the top of the battery into the base of the
phone, make sure to touch the metal contact on the phone,
then push the battery down and snap it into place.
Note:
Your phone is designed to be used only with original
batteries and chargers. Use of other batteries or chargers
may cause damage to your phone and the warranty will be
void.
Removing the battery
Make sure your phone is powered off to avoid the important
information getting lost.
Hold battery bottom and remove the battery from the
phone.
5
To Next Page
Loading...
