28
1.Drain pipe is knotted or not.
2.Filter in drain pump is blocked or not (refer to the cleaning of filter in drain
pump)
Electronic module fails(F04, F05,F06,F07,F23).
Important: Ensure that the water has cooled before draining the appliance
3.Drain hose is frozen up .
Plug in the appliance again,
Restart the desired programme. If fault occurs again, please contact with
after-sale service (refer to after-sale service.).
The washer stops when the program is running. The display
window shows fault codes from “F04 to “F07”, “F23” .
If fault code “F04” to “F07”, “F23” shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the
machine.
After fault is removed, press “Start/Pause” key. If fault
occurs again, disconnect power supply and contact
with after-sale service.
“F03” displayed on screen
The washer is not emptied. The washer stops the program being
executed. Shut down the machine and disconnect power supply.
Check:
“F24”displayed on screen
Water level reaches overflow level.
Remove it by pressing “Start/Pause” key and feed water.
Select and start required program. If fault occurs
again, disconnect power supply and contact with
after-sale service.
To Next Page
