HISON WATERCRAFT
35
2. If required add air to reach the required pressure
3. If too much air is added, air can be released by pushing on the metal stem in the center of
the valve.
4. Recheck the pressure with the tire gauge and adjust if necessary.
5. Refit the valve cap.
Replacement wheels and tires
Only install wheels and tires that match the original specification. The installation of different
wheels or tires may cause you to lose control of the Crosski.
Traction will be seriously impaired if directional tires are incorrectly installed.
Cleaning
△
! CAUTION it is illegal to pollute drains, streams, rivers and waterways of any
description. Always take precautions to prevent spillage of fluids while cleaning. dispose of used
toxic chemicals at authorized waste disposal sites only.
Salt water corrosion prevention
After leaving the water, it is important to thoroughly wash the superstructure and underside,
paying particular attention to the wheel arches, suspension components, water jet and wheel
assemblies.
Washing the Crosski
NOTICE: pressure washers to clean the Crosski damage to components could result
NOTICE: instruments and other electrical components.
Use liberal amounts of water to flush grit and grime from the body before washing.
Wash the bodywork and hull with cold or lukewarm, fresh water and a wash-and-wax soap.
Rinse with clean water after washing, then wipe dry with a cloth to eliminate smears.
Note: avoid washing the Crosski in direct sunlight. Do not use hot water, dish soap or detergent
cleaning products.
Cleaning the instrument panel
Clean the instrument panel using a damp cloth/cleaning wipe. Do not use cleaning
compounds or solutions.
Polishing the bodywork/hull
To preserve the cosmetics appearance of the bodywork and hull, occasionally apply a good
quality polish to the surface.
To Next Page
Loading...