HISON WATERCRAFT
36
A good polish should contain a very mild abrasive that will remove surface contamination
without damaging the surface, a mild filling compound to reduce the appearance of scratching
and wax to provide a barrier between the cleaned bodywork surface and airborne contaminants.
Do not use cutting paste, color restoration compounds or polishes containing a harsh
abrasive. These will scour the resin surface of the bodywork and may cause permanent
degradation of the bodywork.
Damage and rectification
Regularly inspect the bodywork and hull for damage. Any stone chips, fractures or deep
scratches should be repaired promptly.
Repairs to bodywork and hull should only be carried out by a repairer approved by the
manufacturers. Contact a Hison dealer for advice.
Storage
When storing the Crosski for an extended period of time or seasonal, the following is
recommended:
Fill the fuel tank with fuel and mix in a fuel stabilizer: run engine for 3-5 minutes.
Change engine oil and filter.
Remove battery and store in a warm dry location.
Periodically re-charge the battery or leave on a trickle charger.
Drain any excess water from the hull.
Clean the Crosski.
If possible, periodically move vehicle to rotate tires to avoid flat spots.
NOTICE: unheated area and the ambient air temperature is likely to fall below 32°F (0°C), the
Crosski must be emptied of raw water to prevent damage to the cooling system.
Removing Raw Water from the Crosski
Remove the engine safety cut-off to prevent the engine from running and apply the parking
brake to prevent the Crosski from moving unexpectedly.
The Crosski uses raw water heat exchangers to cool the engine oil and coolant when
operating in marine mode. If you are planning to use the Crosski on land, or store the Crosski in
an unheated area and the ambient air temperature is likely to fall below 32°F (0°C), these heat
exchangers must be emptied of raw water to prevent damage to the cooling system.
Transporting
NOTICE: On the ground may cause serious damage to the Crosski engine and drive train.
The only approved method of transporting your Crosski is using a flatbed trailer.
Damage caused by any other means of transportation may void the Warranty Policy.
To Next Page
Loading...