THE REMOTE CONTROL (CLU-413UI) - 19 -
You can also use the RECALL button to quickly clear many of the other on-screen
displays.
MENU, ENTER, CURSOR buttons
All the on-screen display features can be set or adjusted by using these buttons.
The "MENU" button will start or exit the on-screen display.
The "CURSOR" buttons will highlight functions or adjust different features.
The "ENTER" button will set features to your preference.
"CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc..
CHANNEL SELECTOR buttons
Enter two or three numbers to select channels. Enter a "0" first for channels 1 to 9. Use
the "100" button for channels 100 and higher.
Channel selection may also be performed by pressing channel up ( ) or down ( ).
NOTE: The TV may not receive some channels if you are not in the correct AIR/CABLE
mode. (See page 25)
AVX button
The AVX (Auxiliary Video) button will select between the antenna signal and the two
sets of video input jacks each time the button is pressed. If the Picture-in-Picture (PIP)
is on, the AVX will select between the two sets of video input jacks. (See page 18)
VOLUME, MUTE buttons
To Next Page
Loading...
Need help?
General
