HMCS404CL------------------------------------------------------------------------
Table 7. Serial Mode Register
SMR
Bit 3
o
Used
as
R40
port
input/output
pin
Used
as
SCK
input/output
pin
SMR
Transfer Clock
Prescaler
System Clock
Bit 2
Bit 1 Bit 0
R4o/SCK
Port
Clock Source Divide
Divide
Ratio
Ratio
0
0
0
SCK
Prescaler
+ 2048
+4096
Output
0
0
1
SCK
Prescaler
512
+ 1024
Output
0
1
0
SCK
Prescaler
128
256
Output
0
1
1
SCK
Prescaler
32
64
Output
1
0
0
SCK
Prescaler
8
16
Output
1
0
1
SCK
Prescaler
2 4
Output
1
1 0
SCK
System
-
1
Output
Clock
1
1 1
SCK External
- -
Input
Clock
Transfer Clock
Serial
Output
Data
Serial
Input
Data
Latch
Timing
I I
II
I I
I·
I
Fig.
10 Serial Interface I/O Timing Chart
• SERIAL Interrupt Request Flag (lFS:
$003,
0)
The SERIAL Interrupt Request Flag will be set after the
eight transfer clock
signals
or transmit/receive discontinued
operation by resetting the
Octal Counter.
• SERIAL Interrupt Mask (lMS:
$003,
1)
The SERIAL Interrupt
Mask
masks the interrupt request.
Table 8. SERIAL Interrupt Request Flag
SERIAL Interrupt Request Flag
Interrupt Request
o
No
Yes
352
Table 9. SERIAL Interrupt
Mask
SERIAL Interrupt
Mask
Interrupt Request
o
Enable
Disable (mask)
• Selection
of
the Operation Mode
Table 10 shows the operation mode
of
the serial interface.
Select a combination
of
the value in the Port Mode Register and
the
Serial Mode Register according
to
Table 10.
Initialize the serial interface
by
the Write Signal to the
Serial
Mode
Register, when the Operation Mode
is
changed.
• Operating State
of
Serial Interface
The serial interface has 3 operating states
as
shown in Fig. 11.
The serial interface gets into
"STS waiting state" by 2 ways:
one way
is
to
change the operation mode by changing the data
To Next Page
