11
Installation
Checking operation
1
Checking after installation
Turn on the water tap and close the washing machine door.
2
Press the Power button to switch power on.
3
Select the cotton program and press the Start/Pause button.
4
After 5 minutes, check if there is no water leakage from anywhere.
5
Press the Power button to switch power off.
6
Press the Power button again to switch power on.
7
Select the Spin program and press the Start/Pause button.
8
Check if there is no abnormal vibration or sound, and that water is drained out properly.
If any of the following conditions or other abnormalities occur, immediately pull out
the power plug to prevent an accident and contact your local service center.
● The washing machine does not operate when you switch power on.
● The power cord has cracks.
● There are abnormal vibrations and sounds during operation.
● There is a smell of burning.
To Next Page
Loading...
