Hitachi BD-80CE - Drain Hose Installation

Drain Hose
WARNING
！
WARNING
！
10
Installation
Water Supply Hose
Water Inlet Valve
●
Do not kink or protract the drain hose.
Position drain hose properly, otherwise damage might result of water leakage.
●
There are two ways to place the end of drain hose:
Water
trough
Min.60cm
Max.
100cm
1.Put it into the water trough.
2.Connect it to the branch drain pipe of
the trough.
NOTE
If the machine has drain hose support, please install it like the following.
●
Trough
Hose Retainer
Bind
Max.100cm
Min.60cm
Min.60cm
Max.100cm
●
●
When installing drain hose, fix it properly with a rope.
If drain hose is too long, do not force it into washing machine as it will cause
abnormal noises.
Hose Connector
Rubber Seal
● Connect the other end of inlet pipe to the inlet valve at the backside of product
and fasten the pipe tightly clockwise.
● Optimum water pressure is 0.05~1.0MPa.