Why does my Hitachi CG 14DSDL Trimmer go on, but soon stops?
Your Hitachi Trimmer may stop soon after starting due to two main reasons: * The rechargeable battery power is low, so you should charge it. * The rechargeable battery is overheated. Stop using it, remove it from the tool, and allow it to cool in a well-ventilated area away from sunlight.
How to fix strong vibrations in my Hitachi CG 14DSDL Trimmer?
If you're experiencing strong vibrations with your Hitachi Trimmer, it could be due to: * The loop handle not being properly attached to the main pipe, so ensure it is securely fastened. * The cover not being properly attached to the main pipe, so make sure it is securely attached.
What to do if the charge lamp does not go on for Hitachi CG 14DSDL Trimmer?
If the charge lamp on your Hitachi Trimmer isn't lighting up, check the following: * Ensure the power plug is properly connected to an AC outlet. * Verify the battery is correctly seated in the charger. * Inspect the battery and charger electrodes for dirt; clean them with a cotton swab if necessary. * If the battery is extremely hot, let it cool down before attempting to charge it.
What to do if my Hitachi Trimmer does not operate?
If your Hitachi Trimmer isn't operating, there are a few possible reasons. First, the rechargeable battery may be depleted, so try charging it. Second, the rechargeable battery might not be properly installed; remove it, check for any foreign matter or soiling, clean with a cotton swab if needed, and ensure it clicks into place when re-inserted. Finally, make sure the power is on by pressing the power button on the housing. Remember that the tool has an auto power off function that activates after one minute of inactivity; press the power button again to restart.
What to do if the Hitachi Trimmer pulls in large volumes of grass?
If your Hitachi Trimmer is pulling in large volumes of grass and overloading, turn off the tool and remove the cause of the overload. Then, press the power button once again to continue operation.
Why does the Hitachi Trimmer have strong vibrations?
Strong vibrations in your Hitachi Trimmer can occur if the loop handle or the cover are not properly attached to the main pipe. Ensure both are securely fastened.
What to do if the charge lamp does not go off after 4 hours of charging for Hitachi Trimmer?
If the charge lamp on your Hitachi Trimmer remains on after 4 hours of charging, disconnect the power plug. The battery or charger may be faulty.
What to do if my Hitachi Trimmer tool does not operate?
If your Hitachi Trimmer isn't working, there are several potential causes: * The rechargeable battery may be depleted and needs charging. * The rechargeable battery may not be properly installed. Remove the battery, check for any foreign matter or soiling on the electrodes (clean with a cotton swab if needed), and ensure it clicks into place. * The power may not be turned on. Press the power button on the housing to start the tool. Remember the tool has an auto power off function if the lever isn't used within one minute of powering on; press the power button again. * The lock lever may not have been pressed when pulling the lever back. Hold the handle from above, press the lock lever, and then pull the handle. * The tool may be overloaded with grass caught between the cover and...
General| Power Source | Battery |
|---|---|
| Battery Voltage | 14.4 V |
| Cutting Width | 300 mm |
| No Load Speed | 6, 000 rpm |
| Shaft Type | Straight |
To Next Page