USB Display (continued)
This application will appear in the Windows notication
area once it starts. You can quit the application from
your computer by selecting “Quit” on the menu.
• The “LiveViewer” (refer to the User's
Manual - Network Guide) and this application
cannot be used at the same time. If you connect
your computer to the projector by using a USB
cable while the “LiveViewer” is running, the following message will be displayed.
• Depending on the software installed on your computer, images on your
computer cannot be transferred using “LiveViewer Lite for USB”.
• If any application software having the rewall function is installed into your
computer, make the rwall function invalid with following the user's manual.
• Some security software may block image transmission. Please change the
security software setting to allow the use of "LiveViewer Lite for USB".
• If the computer in use is equipped with HDMI port, the audio setting will be
changed and sound interruption or noise may occur when the HDMI cable
is connected or disconnected during USB Display. In this case, restart USB
Display.
• Image distortion or sound interruption may occur when LiveViewer is
connected to LAN during USB Display. The above decline in performance is
noticeable especially when multiple computers are connected to LiveViewer.
NOTE
To Next Page
Loading...
