21
Click the [Apply] button to save the settings.
3.1 Projector Web Control - Network Settings (continued)
Item Description
Wired Setup Configures the wired LAN settings.
IP Configuration Configures network settings.
DHCP ON Enables DHCP.
DHCP OFF Disables DHCP.
IP Address Configures the IP address when DHCP is disabled.
Subnet Mask Configures the subnet mask when DHCP is disabled.
Default
Gateway
Configures the default gateway when DHCP is disabled.
DNS Server Address Configures the DNS server address.
Other Setup Configures other network settings.
Crestron e-Control
Set whether to or not to use Crestron e-Control
®
.
If you choose Disable, the Logon window of Projector Web
Control will be displayed at first, but the selection window will
not appear.
3. Web Control
• The new configuration settings are activated after restarting the
network connection. When the configuration settings are changed, you must
restart the network connection. You can restart the network connection by
clicking [Network Restart] on the main menu (
41).
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• The WEP Key, WPA passphrase and SSID settings will not be set if the invalid
characters are used.
• The projector does not allow both wireless and wired LAN to be connected to
the same network. Do not set the same network address for both wireless and
wired LAN.
NOTE
To Next Page
Loading...
Need help?
General