Hitachi CP-S830W - Page 11

CP-S830W
CP-S830E
4-3 Sample/Hold timing adjustment
Preparations for adjustment
@ Input cross hatch monochrome green with a timing @ Adjust S/H TIMING of adjustment menu (*) so that
signal of SVGA VESA(60). the most bright and same bright at all vertical lines.
@Adjust H.PHASE of menu so that the best at note Never adjust FINE of adjustment menu (*).
vertical lines. * how to set up adjustment menu
@Input vertical line (bright-black-black-bright-black- ist Push MENU bottom 2nd Push RESET bottom
black-bright-.....)monochrome green and keep 5sec. or more. 3rd Select S/H of head
with a timing signal of SVGA VESA(60). line.
4-4 Sensor adjustment
Preparations for adjustment
@Apply heat-running for 10 minutes or more before
adjustment.
Adjustment procedure
Adjust RW04 to get following values.
0.018 + 0.002 [V]
(Connect @ side to TWT1 and Oside to TWT2 by
digital meter.)
S44