Item Description
FRAME LOCK
Set the frame lock function on/off for each port.
(1) Use the ▲/▼ buttons to select one of
following ports.
QUIT
ó
RGB1
ó
RGB2
ó
HDMI
(2) Use the ◄/► buttons to turns the frame
lock function on/off .
TURN ON
ó
TURN OFF
• This item can be performed only on a signal
with a vertical frequency of 50 to 60 Hz.
• When the TURN ON is selected, moving pictures are displayed
more smoothly.
• This function may cause a certain degradation of the picture. In
such a case, please select the TURN OFF.
RGB IN
Set the RGB input signal type for the
RGB port.
(1) Use the ◄/► buttons to select the
RGB
port to be set.
RGB1
ó
RGB2
(2) Use the ▲/▼ buttons to select the RGB
input signal type.
AUTO
ó
SYNC ON G OFF
• Selecting the AUTO mode allows you to input a sync on G signal
or component signal from the port.
• In the AUTO mode, the picture may be distorted with certain
input signals. In such a case, remove the signal connector so that
no signal is received and select the SYNC ON G OFF, and then
reconnect the signal.
(continued on next page)
To Next Page
Loading...
