Hitachi CP-X9110 - Page 128

15
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects (continued)
Phenomenon Cases not involving a machine defect
HDBaseT
connection
does not work
The SAVING function is working.
Select NORMAL for STANDBY MODE item in the SETUP menu.
The connected equipment may not be supported by HDBaseT.
Refer to User's manual(detailed) for connection.
IR and LAN
does not work
via HDBaseT
™
Check if the IR setting is OFF under HDBaseT.
EASY MENU > ADVANCED MENU > OPTION > SERVICE
> REMOTE RECEIV.
Check if the LAN setting is HDBaseT.
EASY MENU > ADVANCED MENU > NETWORK > WIRED
NETWORK
LAN does not
work, if LAN is
connected to
the projector
while having
an input signal
from HDBaseT
Check if the LAN setting is HDBaseT.
EASY MENU > ADVANCED MENU > NETWORK > WIRED
NETWORK
This projector is compatible with 100BASE-T only.
Check the specication of the connected equipments.
If the LAN cable is connected with the hub, try to change the
connected port at the hub
If the LAN cable is connected directly to the computer, try to
connect to other computer
No image is
displayed via
HDBaseT
Check the LAN cable if it is CAT5e certied or higher.
Try to change the LAN cable.
If the LAN cable is connected with more than 3 extension
connector, the transmission of 100 meters may fail.
Check if the extension connector is compatible with CAT5e.
All LAN cable and extension connector connected with HDBaseT
port must be CAT5e certied.