Hitachi D-3300M - Page 7

BATTERY INDICATOR (BATT)
This flashes when the memory back-up batteries are exhausted.
TEST MEMORY BUTTON
Press this to recall the data for the last tape tested.
TAPE SELECT MEMORY BUTTON
Press this to use the tape select memory.
TAPE SELECT BUTTONS
Press
the
button
corresponding
to
the
tape
being
used
for
recording
and
playback.
MEMORY
BACK-UP
BATTERY
COMPARTMENT
(BOTTOM
PANEL)
When
the
battery
indicator
starts
flashing,
the
2
silver
oxide
batteries
should
be
replaced.
TIMER SWITCH (TIMER)
Set the switch to OFF when using the unit normally.
Set
this
switch
to
REC
or
PLAY
for
recording
when
you
are
absent
or
for
timer
PLAY.
To
Set
Power
(Mains)
Voltage:
:
1.
This
unit
can
be
used
with
a
power
(mains)
voltage
of
100
to
110V,
115
to
127V,
200
to
220V
or
230
to
250V.
Before
operating,
be
sure
to
check
your
local
power
(mains)
voltage.
The
Voltage
selector
has
been
set
to
230
—
250V
when
the
set
is
shipped
from
the
factory.
:
2.
Turn
the
Voltage
selector
to
your
local
power
(mains)
voltage
with
a
screwdriver
until
the
selector
clicks.
:
Notes:
1.
Before
turning
the
selector,
disconnect
the
AC
power
(mains)
lead
from
the
AC
outlet
with
this
unit
in
the
stop
mode.
2.
Be
sure
not
to
turn
the
selector
with
a
thin
screwdriver,
etc.
by
force.
The
selector
may
be
broken
and
the
deck
will
not
operate.
3.
When
inserting
the
mains
plug
into
the
AC
outlet
supplying
100
—
110/115
~
127V,
insert
the
plug
with
a
Siemens
adaptor
connected
to
it.