Need help?Do you have a question about the Hitachi DH24PH and is the answer not in the manual?
General| Brand | Hitachi |
|---|---|
| Model | DH24PH |
| Category | Rotary Hammer |
| Language | English |
Ensure a clean, well-lit workspace to prevent accidents and maintain control.
Proper grounding, avoiding wet conditions, and using appropriate cords are crucial.
Stay alert, use protective gear, and prevent unintentional starting for injury prevention.
Use correct tools, maintain them, and store safely to prevent hazards.
All repairs and modifications must be done by authorized personnel.
Verify that the power source conforms to the tool's specified requirements.
Ensure the power switch is OFF before connecting to power to prevent accidental startup.
Use a suitably thick, short extension cord if the work area is distant from the power source.
Follow procedures for securely attaching drill bits to the tool holder.
Attach dust collection accessories for concrete drilling to manage dust effectively.
Choose the correct bit size to prevent damage to screws or the bit.
Set the directional switch (R/L) correctly for desired rotation direction.
Control drill bit speed steplessly by trigger pull; use stopper for continuous operation.
Set mode for drilling and hammering by adjusting the change lever.
Set mode for drilling or driving screws without hammering action.
Set mode for chiseling, groove digging, and edging tasks.
Adjust and secure the depth gauge for precise drilling depth control.
Instructions for mounting and removing taper shank bits using adapters.
Securely attach the core bit, center pin, and guide plate to the rotary hammer.
Use light pressure, establish hole position, and remove components after drilling.
Remove the core bit shank from the hammer using a hammer.
Check drill bits for abrasion and resharpen or replace them.
Regularly check and tighten all mounting screws for safety.
Protect the motor winding from damage, oil, or water.
Carbon brushes should only be inspected and replaced by authorized service centers.
Return the tool to an authorized service center if the supply cord is damaged.
A list of service parts for reference when requesting repairs.
To Next Page