Hitachi DS 18DFL - Performance Analysis; DS 18 DFL Performance Per Charge

--- 8 ---
Type of work
Maker
Model
Working capacity (*1)
Driling
speed
(sec./pc.)
0
50
*500
100
*750
150
*250
200
< High speed >
< Low speed >
*1000
DS 18DFL
HITACHI
C
DS 18DVF3
4.4
4.7
4.9
< Low speed >
< Low speed >
DS 18DFL
HITACHI
C
DS 18DVF3
DS 18DFL
HITACHI
C
DS 18DVF3
DS 18DFL
HITACHI
C
DS 18DVF3
6.0
11
4.1
4.6
5.1
6.0
0.6
0.9
0.4
0
73
80
77
73
65
90
87
60
72
*542
*650
*487
7. WORKING PERFORMANCE PER SINGLE CHARGE
7-1. Model DS 18DFL
Drilling and fastening performance comparison per charge
Remark*: Number of machine screws fastened per charge
Remark*1: Number of holes or fasteners per charge
The above table shows an example of test data. The batteries used in this test are as follows:
Model DS 18DFL: 1.5 Ah
Model DS 18DVF3: 1.4 Ah
C: 1.5 Ah
As actually measured values listed in the above table may vary depending on sharpness of the drill bit, workpiece hardness (particularly in
wood materials), moisture content of wood, charging condition, operator skill, etc.
This data should be used as a comparative guide only.