– 19 –
ATTACHING THE AIR PURIFYING FILTERS
1
Open the front panel
● Pull up the front panel by holding it at both sides
with both hands.
2
Remove the Pre-fi lter
● Push upward to release the claws and pull out the
Pre-fi lter.
3
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into Pre-fi lter frame.
4
Attach the Pre-fi lters
● Attach the Pre-fi lters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the Pre-fi lters, push the front panel at
three arrow portions as shown in fi gure and close it.
!
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Please do not smell direct from
source of fi lter.
NOTE
● In case of removing the air purifying fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying fi lters are not washable. It is recommended to use vacuum to clean it. It can be use
for 1 year time. Type number for this air purifying fi lter is <SPX-CFH22>. Please use this number
for ordering when you want to renew it.
● Do not use detergent on the air purifying fi lter as some detergent may deteriorate the air purifying
fi lter electrostatic performance.
CAUTION
To Next Page
Loading...
Need help?
General
