--- 5 ---
4-7. Wheel Guard Angle-Adjustable without Using a Tool
By following the procedure described below once, the newly developed tool-less wheel guard can be adjusted to a
desired angle without using any tool.
[Installation and adjustment of the wheel guard]
Set the Wheel Guard Ass'y [36] <36> (36) on the Packing Gland [27] <27> (27).
With the Lever [31] <31> (31) closed, tighten the Bolt M8 x 22 [32] <32> (32) until the wheel guard is locked in
position.
Open the Lever [31] <31> (31) for angle adjustment of the wheel guard. (If the wheel guard is difficult to turn,
loosen the Bolt M8 x 22 [32] <32> (32) and readjust the wheel guard.)
Be sure to close the Lever [31] <31> (31) after finishing adjustment before starting operation.
When the Lever [31] <31> (31) becomes dull in motion, lubricate the sliding area between the Set Piece [34]
<34> (34) and the Lever [31] <31> (31).
Fig. 8
To Next Page
Loading...
Need help?
General
