4
English
5) Service
a) Have your power tool serviced by a qualifi ed repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach
of children and infi rm persons.
DEMOLITION HAMMER SAFETY WARNINGS
1. Wear ear protectors.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
4. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
5. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
6. Properly set the bit holder
7. At the start of work, confi rm screw tightening.
8. When working at a highly elevated location, pay
attention to articles and persons below.
9. Wear protective shoes to protect your feet.
SPECIFICATIONS
Voltage (by areas)*
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
Power input 1240 W*
Full-load Impact Rate 1400 /min
Weight (without cord) 18 kg
* Be sure to check the nameplate on this Demolition Hammer as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Bull Point ....................................................................1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
○ Asphalt Cutting
(1) Cutter
Overall Length: 410 mm
Width: 75 mm
○ Groove Digging and Edging
(1) Cold Chisel
Overall Length: 410 mm
○ Tamping
(2) Shank
Overall Length: 250 mm
(1) Rammer
Outer diameter: 200 mm
○ Scooping Work
(1) Scoop
Overall Length: 380 mm
○ Grease
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without notice.
APPLICATIONS
This Demolition Hammer should be applied to demolishing
concrete, chiseling off concrete, grooving, bar cutting
installation of piping and wiring, sanitary facility installation,
machinery installation, water supply and drainage work,
interior jobs, harbor facilities and other civil engineering
works.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate of this Demolition Hammer.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, this Demolition Hammer
will start operating immediately, which could cause a
serious accident.
000BookH70SA.indb4000BookH70SA.indb4 2015/06/1112:11:192015/06/1112:11:19
To Next Page
Loading...
