Hitachi PC-ARH1E - Input;Output Number Display and Connectors; Input;Output Settings and Display Codes

No. Item Optional function
Individual
Setting
Settings Setting conditions Description
51
EF
Control in “Automatic” indoor
fan speed mode (supporting
High H)
Models:
RCI-FSN4
RCIM-FSN4E
RCD-FSN3
RPC-FSN3
RPI-FSN5E
RPI-FSN3E(P)E(-f)
RPIM-FSN4E(-DU)
RPK-FSN(H)3M
○
00 Function disabled
This function limits the speed
of the indoor fan when room
temperature is close to the setting
temperature, allowing to reach
High H speed.
01 Function enabled
52
F0
Not available -
“- -”
permanent
– –
53
F1
Automatic OFF timer setting
Models:
RCI-FSN4
RPC-FSN3
RPK-FSN3M
RPI-FSN5E
RPIM-FSN4E(-DU)
RCD-FSN3
RCIM-FSN4E
RPI-FSN3(P)E
×
00
Function disabled
(Factory setting)
This function sets an automatic
OFF timer to switch OFF the
indoor units controlled by the
remote control switch (when the
units have been started by remote
control).
(Do not set the values "0C"-"0F"
whentwo remotecontrol switches
are used in the same remote
controlgroup)
01 1 hour
02 2 hours
03 3 hours
04-24 (04-24) hours
0A 30 minutes
0B 90minutes
0C 40 minutes
}
Do not set these
when two wired
controllers are
used.
0D 45 minutes
0E 50 minutes
0F 55 minutes
Automatic OFF timer setting
Models:
RPF(I)-FSN2E
×
00
Function disabled
(Factory setting)
This function is used to set the
automatic timer to switch off
when the unit has been started by
remote control.
01 1 hour
02 2 hours
03 3 hours
04-24 (04-24) hours
0A 30 minutes
0B 90minutes
54
F2
Remote control main-sub
setting
×
00
Main (Master remote control)
(Factory setting)
Thisfunctionisusedtodene
which remote control switch is
used as master or slave, when two
remote controllers are connected
to one indoor unit.
01 Sub (Slave remote control)
55
F3
Automatic reset of setting
temperature
×
00
Function disabled
(Factory setting)
This function is used to limit unit
operation and save energy.
The setting temperature is
automatically set to the value
denedwithfunctions"F5"or"F6",
according to the current operation
mode, after the time set with
function"F4"haspassedsince
the last manual change of setting
temperature.
Incasethatthevaluesof"F5"or
"F6"areoutofthelimitssetwith
functions"FC"and"Fd",limitations
setby"FC"and"Fd"havepriority.
01 Function enabled
56
F4
Automatic reset time ×
00 30 minutes (factory setting)
This function sets the automatic
reset time delay for function F3.
01 15 minutes
02 60 minutes
03 90minutes
OPTIONAL FUNCTION
PMML0497 rev.1 - 12/2020
15
ENGLISH