No. Item Optional function
Individual
Setting
Settings Setting conditions Description
57
F5
Automatic reset temperature
for cooling
×
19 19°C
Thisfunctiondenesthedefault
temperature set point for the
automatic reset function F3 in
FAN/COOL/DRY modes.
20 20 °C
21 21 °C
·
·
·
·
·
·
24 24 °C
25 25 °C (factory setting)
26 26 ºC
·
·
·
·
·
·
28 28 ºC
29 29ºC
30 30 ºC
58
F6
Automatic reset temperature
for heating
×
17 17 ºC
Thisfunctiondenesthedefault
temperature set point for the
automatic reset function F3 in
HEAT mode.
18 18 ºC
·
·
·
·
·
·
20 20 ºC
21 21 ºC (factory setting)
25 25 ºC
·
·
·
·
·
·
28 28 ºC
29 29ºC
30 30 ºC
59
F7
Prevention of operation
stoppage due to wrong
operation of the remote
controller
×
00
Function disabled
(factory setting)
Operation is stopped by pressing
the run/stop switch for 3 seconds.
01 Function enabled
60
F8
Lock function for operation
mode selection
×
00 Function disabled
This function is used to prevent
changes to the operation mode.
01
Function enabled
(factory setting)
61
Fg
Lock function for
temperature setting
×
00 Function disabled
This function is used to prevent
changes to the temperature
setting.
01
Function enabled
(factory setting)
62
FA
Lock function for fan speed
selection
×
00 Function disabled
This function is used to prevent
changes to the fan speed.
01
Function enabled
(factory setting)
63
Fb
Lock function for swing
louvre operation
×
00 Function disabled
This function is used to prevent
changes to the automatic louvre
operation.
01
Function enabled
(factory setting)
64
FC
Lower limit of setting
temperature for cooling
(Minimum value of setting
temperature allowed in
cooling)
×
00
Function disabled
19°Cisthestandardminimumset
point. (factory setting)
Thisfunctiondenesthelowest
temperature setting value for FAN/
COOL/DRY modes.
01 +1 ºC (Lower limit 20 ºC)
02 +2 ºC (Lower limit 21 ºC)
03 +3 ºC (Lower limit 22 ºC)
·
·
·
·
·
·
08 +8 ºC (Lower limit 27ºC)
09 +9ºC(Lowerlimit28ºC)
10 +10ºC(Lowerlimit29ºC)
OPTIONAL FUNCTION
PMML0497 rev.1 - 12/2020
16