– 4 –
Setting the desired room temperature. Turn the dial further clockwise for cooler indoor temperature.
●
The compressor operates continuously by setting the temperature dial to
“TEST”. This setting is used for technician. If the unit is operated at this position,
the heat exchanger may freeze and causing water leakage or other malfunction.
Do not set to “TEST” for normal usage.
●
When the compressor stops by turning the temperature dial counterclockwise
in cooling operation, wait 3 minutes before turning it clockwise to restart it.
CAUTIONS
Vertical deflectors at both sides of outlets can
be set to either auto-swing or static position to
direct discharge air rightward, leftward or forward
direction.
Horizontal deflectors at both sides of the outlets
can be set to direct discharge air upward,
downward or forward direction.
Vertical
Deflector
Vertical
Deflector
Horizontal
Deflectors
Horizontal
Deflectors
CAUTION
To avoid dew forming on the deflectors which eventually may drip to the floor, please do not adjust
horizontal deflectors extremely downward position or vertical deflectors extremely leftward or rightward
position during cool operation for a long time.
Also, do not adjust the vertical deflectors position by hand or any other object.
Set the air exhaust lever to the OPEN (pull)
position for air ventilation in the room. The air
exhaust lever should normally be kept in CLOSE
(push inward) position during cooling operation
and in the case of typhoon.
Air Exhaust Lever
AIR EXHAUST LEVER
RA08/10JF2-EN 29/09/2006, 10:03 am4
To Next Page
Loading...
