Press the (START/STOP) button
● Operation start with a “beep”.
Press the (START/STOP) button
● Please make sure you have been selected the (Automatic) mode
by use the (FUNCTION) Button.
● The fan speed selector does not work at this operation.
STOP
Press the (ROOM TEMPERATURE) button
● Temperature setting change by 1°C for each 1 time press.
Up
Down
● You can raise or lower the temperature setting by a maximum of
3°C.
● The display does not indicate the preset temperature in the Automatic
mode. Device will receive the setting by a “beep”.
AUTOMATIC OPERATION
■ The device will automatically determine the operation mode either HEAT, COOL or DEHUMIDIFY,
depending on the initial room temperature.
1
■ You can slightly adjust the room temperature.
1
▲ ▲
● The selected mode of operation will not change during the operation even though the room
temperature change.
■ CONDITION OF AUTOMATIC OPERATION
Over 27°C COOL
23 ~ 27°C
FUNCTION
27°C
Slightly lower than the
room temperature
LOW
FAN SPEED
HIGH at start, LOW after
the preset temperature is
reached
DEHUMIDIFY
INITIAL ROOM
TEMPERATURE (APPROX.)
TEMPERATURE
SETTING
Under 23°C HEAT 23°C
HIGH at start, MED or
LOW after the preset
temperature is reached
– 10 –
To Next Page
Loading...
