– 13 –
ENGLISH
ECO OPERATION
ECO operation is an energy saving function by changing set temperature automatically and by limiting the
maximum power consumption value.
By pressing the (ECO) button during AUTO, HEATING,
DEHUMIDIFYING or COOLING operation, the air conditioner
performs the "ECO" operation.
1
To start ECO operation
To cancel ECO operation
Press
(ECO) button during operation.
“
” is displayed on the LCD.
A beep sound is emitted from indoor unit.
Energy saving operation will start by changing the set temperature
higher or lower automatically and reducing operation power
consumption. This function may vary based on the connected
outdoor unit.
Press (START/STOP) button. Or
Press (ECO) button again.
“
” disappears from the LCD.
A beep sound is emitted from indoor unit.
NOTE
ECO function will not be effective when power consumption is low.
By pressing (POWERFUL) button, ECO operation is cancelled.
After auto restart, ECO operation is cancelled and previous operation mode shall start.
For multi model connections, energy saving operation shall start only by changing set temperature higher
or lower automatically. However, effectiveness of ECO depends on operation conditions.
ECO OPERATION
There are two kinds of ECO OPERATION with sensor or without sensor, depending on models.
Please refer to [Names and Functions of each part] in the unit instruction manual to verify if your unit is
equipped with a sensor and read the following instruction on ECO Operation accordingly.
– 14 –
ECO OPERATION
By pressing the
(ECO) button during AUTO, HEATING,
DEHUMIDIFYING or COOLING operation, the air conditioner
performs the "ECO" operation.
1
To start ECO operation
To cancel ECO operation
Press (ECO) button during operation.
“
” is displayed on the LCD.
Press
(START/STOP) button. Or
Press (ECO) button again.
“
” disappears from the LCD.
NOTE
By pressing (POWERFUL) button, ECO operation is cancelled.
After auto restart, ECO operation is cancelled and previous operation mode shall start.
The sensor detects the presence of people in the room. When nobody is detected, the unit automatically starts
enegy saving operation by shifting the set temperature in two steps.
A beep sound is emitted from indoor unit and the (ECO) lamp
on the indoor unit lights up.
The sensor starts to detect the presence of people in the room.
A beep sound is emitted from indoor unit and the (ECO) lamp on
the indoor unit turns off.
When the presence of people is not detected for 20 minutes, the set temperature is automtatically shifted for
energy saving. If nobody is in the room for 60 minutes , the set temperature is shifted further .
Cooling operation [diagram representation
for illustrative purpose only]
Heating operation [diagram representation
for illustrative purpose only]
The unit returns to normal operation when the sensor detects human movement.
Setting
temperature
20 minutes 60 minutes
Shift
temperature
20 minutes 60 minutes
Shift
temperature
Shift
temperature
Setting
temperature
Shift
temperature
To Next Page
Loading...
