1. Press and hold (OFF) button and (ON) button.
2. Press [RESET] button on the same time. Release [RESET] button only, then release (OFF)
and (ON) button once Screen 1 appears.
Screen 1 Screen 2
3. Press the button to display fan mode (Screen 3).
Screen 3
1. Press the Temperature button ( or ) to change the shift value.
(The shift value is changed with a beep.)
2. Select (FAN SPEED) button to choose Heating Shift or Cooling Shift Mode (Screen 4).
By setting fan speed to HIGH or MED , it will go to Cooling Shift mode.
By setting fan speed to LOW or SILENT , it will go to Heating Shift mode.
Screen 4
NOTE:
1. There are total of 7 shift values ranging from -3 to 3.
2. The displayed shift value, and symbol on the remote controller display will be
disappear after 10 seconds
3. The changed shift value will remain
unchanged after turned off the power.
4. If “0” is displayed on the remote controller display, it indicates the shift value is now at the initial setting.
Decrease 3
㷄
from the initial
shift value setting.
Decrease 2
㷄
from the initial
shift value setting.
Decrease 1
㷄
from the initial
shift value setting.
Increase 1
㷄
from the initial
shift value setting.
Increase 2
㷄
from the initial
shift value setting.
Increase 3
㷄
from the initial
shift value setting.
The initial
shift value setting.
(HEAT) (COOL)
(COOL)
(HEAT)
To Next Page
Loading...
