– 54 –
● The reset circuit initializes the microcomputer program when power is ON or OFF.
● Low voltage at pin 7 resets the microcomputer and Hi activates the microcomputer.
● When power “ON” 5V voltage rises and reaches 4.4V, pin 1 of IC521 is set to “Hi”. At this time the
microcomputer starts operation.
● When power “OFF” voltage drops and reaches 4.2V, pin 1 of IC521 is set to “Low”. This will RESET the
microcomputer.
DESCRIPTION OF MAIN CIRCUIT OPERATION
MODEL RAD-50DH7A, RAD-60DH7A, RAD-70DH7A
1. Reset Circuit
Fig. 1-1
Fig. 1-2
Voltage
5.0V
Reset enter at 4.2V
Reset release at 4.4V
voltage
5.0V
Voltage at pin
7
of microcomputer
Voltage supply to
pin
2
of IC521
To Next Page
Loading...
