– 64 –
5. All systems stop from several seconds to several minutes after operation is started
(all indicators are also off)
Set to the "Hi" fan mode.
The operation lamp lights once and goes out in
5-10 seconds.
Disconnect, CN10 and set to the fan mode again.
The operation lamp lights once and goes out in
5-10 seconds.
Check to see if shorting, etc.
has occurred in the P.W.B.
pattern.
Can the indoor fan be lightly turned by hand?
(Set the power switch to "off" to check.)
Replace the indoor fan motor.
Yes
Yes
Check to see if the indoor fan is
touching the chassis, etc.
If it does, repair.
No
Yes
No
To Next Page
Loading...
Need help?
General
