– 7 –
ENGLISH
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the indoor unit can
be controlled from the remote controller.
●
Transmission sign
The transmission sign blinks when a signal is sent.
●
Display
This indicates the room temperature selected, current time, timer
status, function and intensity of circulation selected.
●
CIRCULATION button
Use this button to set air circulation in the room or start operation.
●
DEHUMIDIFYING button
Use this button to reduce water quantity in the room or start operation.
●
COOLING button
Use this button to set cooling mode in the room or start operation.
●
RESET button
●
STOP button
Press this button to stop operation only.
●
SLEEP button
Use this button to set the sleep timer.
●
FAN SPEED selector
This determines the fan speed. Every time you press this button,
the intensity of circulation will change from (AUTO) to (HI)
to (MED) to (LOW) (during the (FAN) mode, from HI
to MED to LOW).
●
AUTO SWING button
Controls the angle of the horizontal air deflector and to turn off filter
lamp.
●
TEMPERATURE button
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
●
OFF-TIMER button Select the turn OFF time.
●
ON-TIMER button Select the turn ON time.
Precautions for Use
●
Do not put the remote controller in the following places.
●
In direct sunlight.
●
In the vicinity of a heater.
●
Handle the remote controller carefully. Do not drop it on the
floor, and protect it from water.
●
Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the
power cord and plug it in again).
This is to protect the device and does not indicate a failure.
●
If you press the FUNCTION selector button during operation,
the device may stop for about 3 minutes for protection.
CIRCULATION / START
DEHUMIDIFY / START
COOLING / START
FAN
FAN SPEED
LOW
MED
HI
SLEEP TIMER
STOP
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
To Next Page
Loading...
Need help?
General
