Q7
I would like to clean the inside of
the air-conditioner with a
commercially available detergent.
A long time has passed since I
started to run the air-conditioner.
But its temperature and humidity
settings don't match the current
ones.
Q8
Q1
The timer will not become set.
The current time display will
disappear at once.
Q2
Q3
I made a timer "reservation". But
the time setting has disappeared.
I tried to set the "sleep" timer
while the ON timer is reserved.
But it will not set itself to a desired
time.
Q4
The time set in the "sleep" timer can be set with a
time up to the time set with the ON timer. If the end
time of the "sleep" timer is past the time set with the
ON timer, you cannot make that setting.
A4
Is the time not past the reserved time?
The set time disappears when the current time
reaches the reserved time.
A3
The current time
disappears 10 seconds
later. The timer set
display is given priority.
A2
Have you set the product to the current time? The
timer cannot be set unless it is set to the current
time.
A1
It is set to mold monitoring. And it
will not stop even when the
humidity is about 50%.
Setting the product to mold monitoring will cause
continuous operation for 4 hours at first. After that,
under conditions with much ingress of moisture, the
product may run intermittently at intervals of about
20 minutes.
The product may not reach its room temperature or
humidity setting depending on the number of people
in the room, room conditions, outdoor temperature
or other factor.
Even if the room temperature and humidity have
reached their settings, the product may repeat
running and pausing. Depending on the operation
status, therefore, the temperature and humidity
settings may not match the current temperature and
humidity settings.
A commercially available detergent or something
similar may crack the resin parts or block the
drainage channel. It may also result in water
dripping or electric shock. Therefore please do not
use any such product. Moreover, a drip of
detergent on the electrical dust collector, electrical
parts or motor may result in a breakdown, smoking
fire or electrical shock. Users are therefore not
allowed to clean the inside of the air-conditioner on
their own.
A8
Q
9A9
A7
When set to the current
time setting, the reading
blinks for about 3 minutes.
Wireless remote control
– 103 –
To Next Page
Loading...
