To Next PageTo Next Page
Need help?Do you have a question about the Hitachi RAS-20FSXNSE and is the answer not in the manual?
General| Category | Heat Pump |
|---|---|
| Cooling Capacity | 2.0 kW |
| Heating Capacity | 2.5 kW |
| Power Supply | 220-240V, 50Hz |
| Weight (Indoor Unit) | 9 kg |
| Noise Level (Outdoor) | 50 dB |
Guides the selection of the appropriate optional piping connection kit based on operating mode and unit count.
Guidelines for selecting correct pipe sizes for heat pump and heat recovery systems.
Procedures for performing refrigerant charge, including air-tight testing and insulation.
Methods for calculating required additional refrigerant based on piping and unit configurations.
Wiring diagrams and procedures for connecting power supply to outdoor and indoor units.
Overview and location of DIP switches (DSW) on the PCB1.
Procedure for setting the refrigerant cycle number for outdoor and indoor units.
DIP switch settings for various test run and service modes.
Procedure for setting the outdoor unit number and function in combination systems.
DIP switch settings for supply voltage and system type (Heat Pump/Recovery).
Essential checks to perform before carrying out the test run and commissioning.
Details on safety devices and their combinations that protect the compressor.
