– 19 –
ENGLISH
ATTACHING THE AIR PURIFYING FILTERS
1
Open the front panel.
● Pull up the front panel by holding it at both sides with
both hands.
2
Remove the pre-fi lter.
● Push upward to release the claws and pull out the
pre-fi lter.
3
Attaching the air purifying fi lters to the fi lter frame.
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion into
fi lter frame.
4
Attach the pre-fi lters.
● Attach the pre-fi lters by ensuring that the surface written
“FRONT” is facing front.
● After attaching the pre-fi lters, push the front panel at
three arrow portion as shown in fi gure and close it.
Cleaning and maintenance must be carried out only by qualifi ed service personal. Before cleaning,
stop operation and switch off the power supply.
CAUTION
CAUTION
Do not bend the air purifying
fi lter as it may cause damage to
the structure.
Please do not smell direct from
source of fi lter.
NOTE
● In case of removing the air purifying fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Do not operate the air conditioner without fi lter. Dust may enter the air conditioner and fault may
occur.
Claws
(4 places)
30MH1 15-24.pdf 5 2/19/14 11:28 AM
To Next Page
Loading...
