– 6 –
NAMES AND FUNCTIONS OF REMOTE CONTROL UNIT
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If indoor lighting
is controlled electronically, the range of control may be shorter.
This unit can be xed on a wall using the xture provided. Before xing it, make sure the indoor unit
can be controlled from the remote controller.
● Transmission sign
The transmission sign blinks when a signal is sent.
● Display
This indicates the room temperature selected, timer status, function
and intensity of circulation selected.
● CIRCULATION button
Use this button to set air circulation in the room or start operation.
● DEHUMIDIFYING button
Use this button to dehumidify the room or start operation.
● COOLING button
Use this button to set cooling mode in the room or start operation.
● RESET button
● SUPER COOLING button
Use this button to set super cooling operation or start operation.
● STOP button
Press this button to stop operation only.
● SLEEP button
Use this button to set the sleep timer.
● FAN SPEED selector
This determines the fan speed. Every time you press this button,
the intensity of circulation will change from (AUTO) to (HI)
to (MED) to (LOW).
● AUTO SWING button
Controls the angle of the horizontal air de ector.
● TEMPERATURE button
Use this button to raise or lower the temperature setting. (Keep
pressed, and the value will change more quickly.)
● OFF-TIMER button Select the turn OFF time.
● ON-TIMER button Select the turn ON time.
Precautions for Use
● Do not put the remote controller in the following places.
● In direct sunlight.
● In the vicinity of a heater.
● Handle the remote controller carefully. Do not drop it on the
oor, and protect it from water.
● Once the outdoor unit stops, it will not restart for about 3
minutes (unless you turn the power switch off and on or unplug
the power cord and plug it in again).
This is to protect the device and does not indicate a failure.
● If you press the FUNCTION selector button during operation,
the device may stop for about 3 minutes for protection.
To Next Page
Loading...
