– 71 –
Notes:
(1) The indoor fan is operated in the "Lo" or "Silent" mode, OFF for 5 minutes and ON for
1 minute, repeatedly according to the humidity judgement when the thermostat is turned
OFF.
(2) When the operation is started by the thermostat turning ON, the start of the indoor fan
is delayed 32 seconds after the start of compressor operation.
(3) The compressor is operated forcedly for 3 minutes after operation is started.
(4) The minimum ON time and OFF time of the compressor are 3 minutes.
Dehumidifying
preset
temperature
1.33˚C
3˚C
0.66˚C 2.33˚C
Start / Stop switch
Operation lamp
Indoor fan
Outdoor fan
Reversing valve
SDRPM
SDMAX
SDMAXSDMAX
1min.
5min. OFF / 1min. ON
Fan speed set to "Lo"
Room temperature
Room temperature judgement
15sec.
Compressor
rotation speed
STARCPL
Hi
Med
Lo
Silent Sleep
Thermostat judgement
15sec.
1min.
32sec.
See basic operation
Compressor speed
Vertical air
deflector
Outdoor fan
Indoor fan
Timer lamp
Sleep key
Operation lamp
[SLEEP] on the remote
controller is lit
Hi
Med
Lo
Sleep
Silent
Facing up
Horizontal
Shut
Set to 2 hours
Lo
S
1 h r 2 h r0.5 h r
Dehumidifying
Notes:
(1) The sleep operation starts when the sleep key is pressed.
(2) When the sleep key is set, the indoor fan is set to "Sleep Silent" (FDOY).
(3) If the operation mode is changed during sleep operation, the set tempera-
ture is cleared, and shift starts from the point when switching is made.
(4) The indoor fan speed does not change even when the fan speed mode is
changed.
(5) When operation is stopped during sleep operation, the set temperature
when stopped, as well as the time, continue to be counted.
(6) If the set time is changed during sleep operation, all data including set
temperature, time, etc. is cleared and restarted.
(7) If sleep operation is canceled by the cancel key or sleep key, all data is
cleared.
(8) The indoor fan is stopped while the thermo is OFF during sleep operation.
(9) There is no preset temperature shift due to time elapse.
Dehumidifying Sleep Operation
To Next Page