Need help?Do you have a question about the Hitachi RASC-4HNPE and is the answer not in the manual?
General| Brand | Hitachi |
|---|---|
| Model | RASC-4HNPE |
| Category | Air Conditioner |
| Language | English |
Explains symbols used for safety instructions and warnings in the manual.
Provides specific safety warnings and precautions for handling the unit and its components.
Provides instructions and safety precautions for lifting the unit using ropes.
Details proper lifting and handling based on the unit's center of gravity.
Lists and illustrates parts and dimensions for the RASC-(4-6)HNPE model.
Lists and illustrates parts and dimensions for the RASC-(8/10)HNPE model.
Outlines essential checks before installing the unit.
Specifies clearance and environmental conditions for unit installation.
Details requirements for foundation, drainage, and mounting.
Provides instructions for suspending the unit from the ceiling.
Explains how to adjust fan settings for optimal performance.
Covers considerations for connecting refrigerant piping, including materials.
Details connecting refrigerant piping to the RASC unit.
Provides safety precautions for brazing refrigerant pipes.
Explains the correct procedure for charging refrigerant.
Cautions regarding pressure measurement using check joints.
Details how to calculate necessary refrigerant quantity.
How to install drain piping to prevent freezing and ensure discharge.
Indicates location of drain pipes for different RASC models.
Provides instructions for connecting drain pipes, including siphon.
Details harmonic situations for models per IEC standards.
Illustrates electrical connections between indoor and outdoor units.
Details electrical connections for the RASC unit.
Recommends minimum wire sizes and switch ratings.
Outlines minimum requirements for protection devices.
Shows physical locations of DIP and RSW switches on the PCB.
Explains functions of various dip and rotary switches for unit configuration.
Describes setting end-terminal resistance for H-LINK connections.
Details setting control operation for indoor units.
Explains function selection based on jumper lead settings.
Outlines essential checks before starting the test run.
Details the procedure for performing a test run using the remote control switch.
Lists and describes devices protecting compressor and fan motor.
To Next Page
