12
● Do not install the indoor unit in a machinery shop or kitchen where or its mist flowsoil vapor
to the indoor unit. The oil will deposit on the heat exchanger, thereby reducing the indoor unit
performance, and may deform and in severe case, break the plastic parts of the indoor unit.
● Pay attention to the following points when the indoor unit is installed in a hospital or other facilities
where there are waves from medical equipment:electromagnetic
(A) Do not install the indoor unit where the electromagnetic wave is directly radiated to the electrical
box, remote control cable or remote control switch.
(B) Install the indoor unit and components at least 3 meters from the electromagnetic wave radiator.
(C) Prepare a steel case and install the remote control switch in it. Prepare a steel conduit tube and
wire the remote control cable in it. Then, connect the ground wire with the box and the tube.
(D) Install a noise filter when the power supply emits harmful noises.
● To avoid any corrosive action to the heat exchanger, do not install the indoor unit in an acid or alkaline
environment. If the indoor unit has to be installed in such environments, use corrosion-proof type unit.
Ensure that the number is within 0.3kg/m³. Otherwise it may causebelow calculated
danger situation if the refrigerant in the Outdoor Unit leaks into the room where the Indoor
Unit is installed.
Installation and Maintenance
the
To Next Page
Loading...
