1
1
.
.
O
O
P
P
T
T
I
I
O
O
N
N
L
L
I
I
S
S
T
T
�
The fan speed is changed in sequence:
FAN mode
At "FAN" mode, only "Auto" is not available.
At "DRY" mode, Fan speed is set at "AUTO” automatically, "FAN"
button is ineffective in this case.
Setting temperature
Turning on or off
AUTO, POWERFUL, TIMER and SLEEP operation modes will be specified in the
following pages.
Changing modes during operation, sometimes the unit does not respond at once. Wait for 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－
5 minutes, the air flow will be
discharged until temperature of indoor heat exchanger rises.
Wait for 3 minutes before restarting the appliance.
16℃~30℃
Range of available set temperature
*HEATING, COOLING, DRY
unable to set
FAN
*Note: Heating mode is NOT available for cooling only models.
Press
PressPress
button can change the unit operation status.
Result:
Press Press
Auto
High
Medium
button
Raise temperature by 1℃.
button
Lower temperature by 1℃.
Press
Result:
Result:
Low
Quiet Low
PRESS
Press MODE button and cancel AUTO mode.
Note: Temperature, airflow and direction are controlled automatically in AUTO mode.
AUTO mode
How to set AUTO mode?
Press the AUTO button.
Result: Enters AUTO mode (fuzzy logic operation).
Mode and fan speed are automatically
set based on the actual room temperature.
PRESS
Your feeling
What you can do in AUTO mode?
Button
Adjust
Uncomfortable because
of unsuitable air flow
volume.
Uncomfortable because
of unsuitable flow
direction.
Indoor fan speed alternates among Auto, Low,Medium
and High each time this button is pressed.
Press it once, the horizontal adjustment louver (vertical
adjustment louver) swings to change vertical airflow
direction (horizontal airflow direction). Press it again,
swings stops.
button repetitively.
To Next Page
Loading...
