EasyManua.ls Logo

Hitachi RCI-4.0FSN3 - 9.4 CHARGING WORK

Hitachi RCI-4.0FSN3
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TC-12001
2-139
AIR PANEL
8
5. Electrical Wiring
O
Perform securely the electrical wiring work.
If the electrical work is not completed, heat
generation at the connection, a ¿UH or an electric
shock may occur.
O
Make sure that the wires are securely ¿[HG
in RUGHU not to apply an H[WHUQDO force to the
terminal connections of the wirings. If ¿[LQJ is
not FRPSOHWHG heat generation or a ¿UH will
occur.
1) The following connectors are used in the air panel.
Remove the tape ¿[LQJ the ZLULQJ FRQQHFWRUV RQ the
DLU SDQHO DQG SXOO out them DV VKRZQ LQ the ¿JXUH
below. Connect them with the wiring connectors on
the indoor unit.
Before the electrical wiring work, turn OFF the
power source. If the connectors are connected
without turning OFF the power source, the auto
swing louver can not activate.
2) After completing the wiring connection of the
air panel, attach the air inlet grille. Perform
the attaching work in the reverse procedure of
removing. (Refer to item 3) of “Installation”.) Hook
the swivel of the supporting string at
A
to the hole
at the air panel. The air inlet grille can be attached
from any 4 directions by rotating it. When multiple
indoor units are installed or requested from a user,
the air intake grille direction can be selected freely.
(e) While pushing the wiring into the corner pocket,
LQVHUW the ¿[LQJ KRRNV (2 SRUWLRQV at
A
to the
square hole at the air panel, and push the corner
pocket cover toward the arrow direction (
A
).
7KHQ LQVHUW the ¿[LQJ hook (1 SRUWLRQ at
B
to
the square hole at the air panel.
NOTE:
Catch VHFXUHO\ the ¿[LQJ KRRNV of the FRUQHU
pocket cover to the air panel.
If QRW the ¿[LQJ KRRNV ZLOO be GDPDJHG
11) In Case of Removing Corner Pocket Cover
Remove the corner pocket covers.
The corner pocket covers can be removed pulling
A
part toward the arrow direction.
Fixing Hook
Fixing Hook
B
A
A
A
B
>PS<
HS-HB
Electrical Box
Condition without
Air Intake Grille
Motor Wiring for Auto Louver
(On Air Panel)
(Connector for Low Voltage:
18 Poles, White)
Motor Wiring for Auto Louver
(On Indoor Unit)
(Connector for Low Voltage:
18 Poles, White)
Supporting String
Part
Hole at Air Panel
A
A

Other manuals for Hitachi RCI-4.0FSN3

Related product manuals