< For P-AP160NAE >
Attach the corner pocket covers (3 portions) and the
corner pocket cover with motion sensor (1 portion)
after the air panel is mounted completely.
(a) Catch the band at the rear side of the corner
pocket cover onto the projection at the air panel
as shown in the ¿JXUH below IRU 3 FRUQHUV
NOTE:
Catch securely the band onto the projection.
If not, the comer pocket cover may fall down
when removing it so that may cause injury.
NOTE:
Catch VHFXUHO\ the ¿[LQJ hooks of the FRUQHU
pocket cover to the air panel.
If not, the ¿[LQJ hooks will be GDPDJHG
(c) Draw out the relay wire from the corner pocket
of the air panel. Connect the wiring for motion
sensor at the corner pocket cover to the relay
FRQQHFWRU as the IROORZLQJ ¿JXUH
After connecting, cover the relay connector
connection E\ the ZLULQJ FRYHU and ¿[ the ZLULQJ
cover by the plastic bands.
(d) Catch the band at the rear side of the corner
pocket cover with motion sensor onto the
SURMHFWLRQ at the DLU panel as shown in the ¿JXUH
below.
NOTE:
Catch securely the band onto the projection.
If not, the comer pocket cover may fall down
when removing it so that may cause injury.
E ,QVHUW the ¿[LQJ hooks (2 SRUWLRQV at
A
to the air
panel and LQVHUW the ¿[LQJ hook (1 SRUWLRQ at
B
to the air panel (for 3corners).
Band
Projection
Fixing Hook A
B
Fixing Hook
B
A
A
Air Panel
Corner Pocket
Relay Wire
Corner Pocket
Cover with
Motion Sensor
Plastic Band
Relay
Wiring Cover
Plastic Band
Connector
Projection
Band
To Next Page
Loading...
