Hitachi RCIM-2.0FSN - 13.2. ELECTRICAL WIRING CONNECTION FOR OUTDOOR UNITS; Outdoor Unit Wiring Diagram; 13.2.1. SETTING OF DIP SWITCHES FOR OUTDOOR UNIT; Outdoor Unit DIP Switch Settings

ELECTRICAL WIRING
23
13.2. ELECTRICAL WIRING CONNECTION FOR OUTDOOR UNITS
 The electrical wiring connection for the outdoor unit is
shown in figure below:
RAS-2/2.5
HVRN1
L1
L2
N
12
{{{{
Power Supply
AC 230 V
Control cable (5V)
 Instructions for wiring and electrical Board
13.2.1. SETTING OF DIP SWITCHES FOR OUTDOOR UNIT
 Quantity and Position of DIP Switches
The PCB in the Outdoor Unit is operating with 7 types of DIP
Switches, and 4 Push Switch. The location is as follows:
 DSW301: Test Run Mode
Setting before shipment
ON
1 2 3 4 5 6
 DSW1: (No setting is required)
When set Nº1 pin to ON, the
electric current detection is
cancelled. Nº1 pin should be set
back to OFF after electrical work.
ON
1 2 3
 DSW2: Pipe length setting (setting is required)
Setting before shipment
ON
1 2 3 4 5 6
Pipe legth (≤5m)
ON
1 2 3 4 5 6
Pipe Length (≥30m)
Pipe length setting should be
performed as follows according to
the on-site pipe length.
ON
1 2 3 4 5 6
 DSW3: Capacity Setting (No setting is required)
Model RAS-2HVRN1
Setting Position
ON
1 2 3 4 5 6
Model RAS-2.5 HVRN1
Setting Position
ON
1 2 3 4 5 6
PCB
Earth terminal
Side cover
Transmission
wires
Power wires