Hitachi RPC-4.0FSR - Page 19

FEATURES
TCI-20007-rev.1
1-9
The air conditioning capacity is saved automatically depending on a situation and the amount of detected
human activity by adopting the motion sensor on the corner of the lower cover. The energy saving can be
improved more with the individual operating function. In addition, the operation can stop automatically if the
absent situation continues for more than 30 minutes
*1)
. The motion sensor keeps the indoor environment
more comfortable and reduces unnecessary operations
*2)
.
*
1)
: The default setting is “30 minutes”. However, the setting is changeable.
*2)
: The default setting is “Running Operation”. However, “Automatic Stop” can be selected by setting
from the wired controller.
Motion Sensor Control
< Detecting Area >
1.8m
9m
7.2m
Floor-to
-
Ceiling
Height
2.7m
Example for 1.5 to 6HP indoor units
Depth 7m
0.8m from Floor Level
Detecting Area
Detecting Area
• Detecting Area for Human Activity
Detecting Diameter: Approx. 7.0m x 7.2m
*3)
(0.8m…height from oor surface)
The motion sensor may not detect human
activity just under the indoor unit
(1.8m x 7.0m).
*3)
: The detecting area is smaller if a person in
the room hardly moves just like when one
stretches on a chair, etc. The detecting
diameter can change to approximately 6.0m.
NOTICE: Motion Sensor
1. The motion sensor detects human activity. However, if someone is in a room with a bit motion, the
motion sensor may detect the absence of human.
2. The motion sensor may detect human activity, if the indoor unit with the motion sensor is installed near
a moving object having di󰀨erent temperature from ambient atmosphere.
3. The motion sensor may detect the absence of human even if someone is in a room, when the indoor
unit with the motion sensor is installed on a high ceiling (higher than 4m).
The outdoor unit connectable to the motion sensor kit is limited. Refer to the table “Corresponding
Outdoor Units for Motion Sensor Function” in the item 6 for the corresponding models.
In the case that the three (3)
indoor units individually
installed to each room are
connected to one (1) outdoor
unit and operated.
In a specific room, the air flow volume
and the air flow direction are adjusted
when there is little human activity
for a period of time.
The operation stops automatically
if the activity is not detected for a period
of time. It prevents to forget the turning off
the switch.
at Normal Operation
at Motion Sensor Activated
Few Human
Activity
or Absence
Little Human
Activity
or Absence
Capacity
Saving
Capacity
Saving
Periodic time has
passed.
Periodic time has
passed.
Prevent to
forget
turning off
the unit.
Prevent to
forget
turning off
the unit.
ATTENTION:
Do not use the motion sensor function when a baby or a handicapped person stays alone.
The motion sensor may detect the absence of human and the operation may stop in the case of someone
staying for long time with a bit motion.