65
4 When you see the part of the program you wish to record, press the PAUSE button on VCR-1 again
to release pause and start recording.
• Press the STOP button to finish recording.
PROBLEM GUIDE / MAINTENANCE
Problem guide
No power
• Make sure the VCR is plugged into an AC outlet.
Remote control doesn't
work
• Make sure the batteries are fresh, and properly
installed.
Won't record
• Safety tab has been removed from cassette (VCR
will
automatically eject the tape).
Won't play back
• Make sure the TV/VCR switch is set to the VCR
mode.
• Make sure the TV is set to the VCR channel (3 or
4) or AUX (if
using direct audio/video hookup).
Won't make timer
recordings
• The VCR power must be turned off to activate
timer recording.
• Clock is not set correctly.
• Programs entered incorrectly.
• Programs exceed the length of the cassette. Use
the EP
recording speed for maximum programming.
• Safety tab has been removed from cassette.
Snowy picture in playback
• Snow or picture noise is normal during search,
still, and slow
Playback.
• Head cleaning may be required.
• Tape is worn or of inferior quality - adjust tracking
controls.
Snowy picture in normal
TV viewing
• Check antenna or cable connections.
Clock shows --:--
• Power has been interrupted - reset the clock.
• Reset the clock.
Erratic VCR display
• Push the reset switch with a sharp pointed
instrument (pen, toothpick, etc.).
Maintenance
To Next Page
Loading...
