Hitachi YUTAKI S RWM-10.0NE - Results

8.5.1.3 Results
Question Description Answers Action
Question 1 Is this device attached to the unit?
No -
Yes It jumps to the question3 and selects automatically “Yes” for the question 2.
Question 2 Is this device controlling the unit?
No -
Yes -
Question 3
Is this device used as a Room
thermostat of a zone?
No
If question 2 is answered as “Yes”:
- Controller type (LCDM) = “Unit”
- Operation view (LCDUop) = “Unit”
Yes, in
zone 1
If question 2 is answered as “Yes”:
- Controller type (LCDM) = “Unit”
- Operation view (LCDUop) = “Unit”
If question 2 is answered as “No”:
- Controller type (LCDM) = “Room”
- Operation view (LCDUop) = “Room”
Controlled circuits (LCDL) = “C1”
Question 11: Minimum “1”
Question 12: Answer forced as “Wired”
Yes, in
zone 2
If question 2 is answered as “Yes”:
- Controller type (LCDM) = “Unit”
- Operation view (LCDUop) = “Unit”
If question 2 is answered as “No”:
- Controller type (LCDM) = “Room”
- Operation view (LCDUop) = “Room”
Controlled circuits (LCDL) = “Room C2”
Question 11: Minimum “1”
Question 12: Answer forced as “Wired”
Yes, in
both zones
If question 2 is answered as “Yes”:
- Controller type (LCDM) = “Unit”
- Operation view (LCDUop) = “Unit”
If question 2 is answered as “No”:
- Controller type (LCDM) = “Room”
- Operation view (LCDUop) = “Room”
Controlled circuits (LCDL) = “C1+C2”
Question 11: Forced to “2”
Question 12: Answer forced as “Wired”
Question 4 How many circuits do you have?
1
Water calculation mode for circuit 1 heating (C1WC) = “Gradient”
Water calculation mode for circuit 1 cooling (CC1WC) = “Fix”
Water calculation mode for circuit 2 heating (C2WC) = “Disabled”
Water calculation mode for circuit 2 cooling (CC2WC) = “Disabled”
2
Water calculation mode for circuit 1 heating (C1WC) = “Gradient”
Water calculation mode for circuit 1 cooling (CC1WC) = “Fix”
Water calculation mode for circuit 2 heating (C2WC) = “Gradient”
Water calculation mode for circuit 2 cooling (CC2WC) = “Fix”
UNIT CONTROLLER
PMML0335A rev.1 - 04/2016
122